To mount your Blink doorbell, follow these steps carefully for a secure and proper installation.
Step-by-Step Mounting Guide
- Prepare the Mounting Location: Tape the provided paper template to the wall 40–48 inches (102–122 cm) above the floor. This ensures an optimal viewing angle.
- Drill Pilot Holes: Using the template as a guide, drill two pilot holes approximately one inch deep (2.5 cm) where indicated. These holes will help secure the mounting screws.
- Remove the Template: Carefully remove the paper template from the wall after drilling.
- Attach the Back Plate: Align the back plate with the drilled holes and secure it to the wall using the provided screws. Be careful not to overtighten the screws, as this could damage the back plate or the wall.
- Complete the Installation: Slide the Blink doorbell onto the mounted back plate until it clicks into place.
Additional Considerations
- Surface Type: If mounting on brick, concrete, or other hard surfaces, use appropriate drill bits and anchors for a secure fit.
- Weather Protection: Ensure the mounting location is adequately protected from direct rain or snow if possible. Consider purchasing a protective cover if needed.
- Power Source: If using a wired Blink Doorbell, ensure you have a nearby power outlet and follow the wiring instructions carefully.
- Wi-Fi Signal: Before permanently mounting, test the Wi-Fi signal strength at the intended location to ensure reliable performance. Consider using a Wi-Fi extender if the signal is weak.
By following these steps, you can successfully and securely mount your Blink doorbell.
