You can adjust your deck level by manipulating the hex nuts on the deck hanger rods. Here's a breakdown:
-
Locate the Adjustment Points: Identify the deck hanger rods and the hex nuts associated with them. These are typically found near where the deck attaches to the mower.
-
Loosen the Lock Nut: Before making any adjustments, loosen the hex lock nut on the deck hanger rod. This allows you to freely adjust the inner hex nut.
-
Adjust the Deck Height:
- Raise the Front: Tighten the inner hex nut to raise the front of the deck.
- Lower the Front: Loosen the inner hex nut to lower the front of the deck.
-
Check the Level: Use a measuring tape to ensure the deck is level from side to side and front to back. The blades should also be at the same height relative to the ground.
-
Secure the Adjustment: Once the deck is at the desired level, tighten the lock nut against the inner hex nut to secure the adjustment.
-
Re-check: After tightening, double-check the deck level to ensure it hasn't shifted during the tightening process.
Important Considerations:
- Safety First: Always disengage the mower blades and turn off the engine before making any adjustments. Remove the key to prevent accidental starting.
- Even Adjustment: Make small, incremental adjustments to each side of the deck to maintain even leveling.
- Consult Your Manual: Refer to your mower's owner's manual for specific instructions and diagrams related to your particular model.
By following these steps, you can effectively adjust your deck level for optimal cutting performance.
