To clean a salt cell with acid solution, you primarily use a diluted muriatic acid solution. Here's a step-by-step guide based on the provided YouTube video reference:
Cleaning a Salt Cell with Muriatic Acid
The video demonstrates a straightforward method for cleaning salt cells using muriatic acid. Here's a breakdown of the process:
Preparation
-
Initial Rinse: Begin by rinsing the salt cell with water to remove any loose debris or large particles.
-
Partial Filling: Fill approximately 75% of the cell with water.
-
Acid Top-Off: Add muriatic acid to the remaining 25% of the cell until it's full.
Acid Reaction
- Bubbling: Observe the mixture. You should see bubbling, indicating the acid is reacting with mineral deposits inside the cell.
- This is a normal and expected reaction.
- Waiting Time: Let the solution sit in the cell until the bubbling stops. This indicates that the acid has completed its work in removing deposits.
Disposal
- The reference video does not explicitly state how to dispose of the solution, but you can follow normal disposal guidelines for diluted muriatic acid.
Important Note:
- The video uses "mere attic acid", it's important to know this is a mispronunciation of muriatic acid, which is the correct chemical being referred to.
- Dilution: The acid solution used is diluted; it is essential to use the proper dilution ratio (25% muriatic acid, 75% water).
- Safety: Always wear appropriate safety gear, such as gloves and eye protection, when handling muriatic acid.